Xantech D5KP User Manual download pdf (Page 10)

- 10 -

Installation

The D5KP is designed to mount in a standard single-gang rough-in box (J Box). Typical mounting

height is 56-60” from the floor to the bottom of the frame. This provides optimum viewing for the

largest number of people.

Note: Do not mount the D5KP in the same rough-in box as high voltage devices such as electrical

outlets or switches.

After running CAT-5 and terminating the ends, route the wires from the D5RH, D5SH, or D5SH4 and

D5IP (if applicable) into the back of the rough-in box, then connect them to the appropriate RJ-45

connectors on the rear of the D5KP. Connect all 16 AWG 2 conductor speaker wires. If using an IR

Receiver, strip the ends of three conductors of the CAT-5 and insert into the screw terminals of the IR

Input Jack. Specific connections are detailed in the Connections section.

Once connections are made, mount the D5KP in to the rough-in box using the 2 provided screws.

Mount the Trim Plate Bracket as shown in the figure below, and then snap the Screw-less Trim Plate

in place.

Make sure that the arrows on both the Trim Plate Bracket and the Trim Plate are pointed UP.

Figure 2.3: D5KP Keypad Installation

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Xantech D5KP User Manual Page 10